Functional Description - Makita VC3211H Instruction Manual

FUNCTIONAL DESCRIPTION

WARNING:
Before plugging the cleaner, always make sure
•
that the cleaner is switched off. Plugging the
cleaner with the switch on may cause an
unexpected start resulting in serious personal
injury.
Switch action
1
2
013369
To start the cleaner, rotate the switch lever to the "I" side.
To stop it, rotate the switch lever to the "O" side.
2
013478
The suction force can be adjusted according to your
work need.
Suction force can be increased by turning the suction force
adjusting knob from the
Also, set the hose diameter selection dial to the hose's
diameter that you are going to use.
Hose diameter selection dial
Turn the dial direction in accordance with the hose you
use.
NOTE:
Do not set the dial at the middle. Always turn either side
according to the hose diameter.
Warning beep
There are two types of beeping sound. One is short
beeps, and the other is long beep.
When the air flow speed falls under 20 m/s, the cleaner
emits short warning beeps for safety reasons. When it
sounds, check the hose diameter selection dial or if the
suction force is not too low. If the beeps keep sounding,
perform maintenance or ask your local service center.
1. Suction force
3
adjusting knob
2. Hose diameter
selection dial
3. Switch lever
1. Suction force
1
adjusting knob
2. Hose diameter
selection dial
3. Switch lever
3
symbol to the symbol.
When the tank is filled with liquid, the cleaner emits long
warning beep.
When the tank is full and the beep sounds, switch off
the cleaner and empty the tank.
Connecting electric power tools
WARNING:
Make sure that both the cleaner and the electric
•
power tool are switched off before connecting or
disconnecting. Connecting the power tool to the
cleaner with both of them being switched on may
cause unexpected and sudden start resulting
serious personal injury.
Never connect an electric power tool with an input
•
power exceeding
"SPECIFICATIONS" to the socket of the cleaner
by turning the suction force adjusting knob.
Connecting the electric power tool exceeding the
specified input power may cause overheat and
damage to the cleaner.
When connecting a grounded tool, insert a plug
•
with a grounding plate to the socket of the cleaner.
The cleaner can be connected to an electric power tool
up to input power shown in the "SPECIFICATIONS".
1
2
3
013371
2
013478
1. To connect an electric power tool, open the outlet
cap and insert the power tool plug into the socket
of the cleaner.
5
that specified
1. Outlet cap
4
2. Power supply
5
cord
3. Hose diameter
selection dial
4. Suction force
adjusting knob
5. Switch lever
1. Suction force
1
adjusting knob
2. Hose diameter
selection dial
3. Switch lever
3
in the