Operation; Testing The Safety System - Makita XTP02 Instruction Manual

4. After loading pin nails, push back the magazine in
place until it clicks.
To remove pin nails, follow the installation procedures
in reverse.
Nose adapter
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before installing the nose adapter.
When firing pin nails on the material with easily-marred
surfaces, use the nose adapter. To install the nose
adapter, place it over the driver guide cover so that the
protrusion inside the nose adapter fits to the dent in the
driver guide cover.
You can store the nose adapter on the holder on the
back end of the magazine to keep it from being lost.
4
3
► 1. Dent 2. Protrusion 3. Nose adapter 4. Holder
Hook
CAUTION:
Do not hang the hook from the
waist belt. Dropping the pin nailer, which is caused
by the hook accidentally coming out of place, may
cause unintentional firing and result in personal
injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
► 1. Groove 2. Hook 3. Screw
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
2
► 1. Hex wrench

OPERATION

Testing the safety system

WARNING:
in working order before operation. Failure to do
so may cause personal injuries.
1
2
► 1. Trigger-lock button 2. Switch trigger 3. Contact
element 4. Magazine
8 ENGLISH
1
2
3
1
Make sure all safety systems are
3
4