Table of Contents
Advertisement
Blade Installation
Review this section, even if your saw blade came
pre-installed.
To install blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Raise arbor all the way up with handwheel,
then remove blade guard, spreader/riving
knife (see Pages 34 & 38), and table insert if
they are installed on machine.
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Before proceeding with the next step, wear
gloves to protect your hands while handling
and installing the blade.
3.
Push arbor lock (see Figure 46) in and turn
blade until it locks in place.
Arbor Lock
Figure 46. Location of arbor lock.
Model G0899 (Mfd. Since 10/20)
4.
While pressing arbor lock, use included arbor
wrench to loosen and remove arbor nut,
flange, and blade (see Figure 47). Arbor nut
has right-hand threads; rotate counterclock-
wise to loosen.
Figure 47. Example of removing table saw
blade.
-33-
Advertisement
Table of Contents
