Makita GA7040S Instruction Manual page 5

ENGLISH (Original instructions)
1. Shaft lock
2. Motor housing
3. Lock button
4. Handle
5. Switch trigger
6. Lock lever
7. Wheel guard
8. Screw
9. Bearing box
10. Nut
11. Lever
SPECIFICATIONS
Model
Depressed center wheel
diameter
Max. wheel thickness
Spindle thread
Rated speed (n)/No load speed (n
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The followings show the symbols which may be used for
the equipment. Be sure that you understand their
meaning before use.
......... Read instruction manual.
.......... Wear safety glasses.
................ DOUBLE INSULATION
.................. Only for EU countries
Due to the presence of hazardous
components in the equipment, used
electrical and electronic equipment
may have a negative impact on the
environment and human health.
Do not dispose of electrical and
electronic appliances with household
waste!
In accordance with the European
Directive on waste electrical and
electronic equipment and its adaptation
to national law, used electrical and
electronic equipment should be
collected separately and delivered to a
Explanation of general view
12. Lock nut
13. Depressed center wheel
14. Super flange
15. Inner flange
16. Lock nut wrench
17. Abrasive disc
18. Rubber pad
19. Wire cup brush
20. Wire wheel brush
21. Abrasive cut-off wheel/diamond
wheel
GA7030/GA7030S
180 mm
6.5 mm
M14
) 8,500 min
0
511 mm
6.0 kg
END202-10
22. Wheel guard for abrasive cut-off
wheel/diamond wheel
23. Outer flange 78
24. Inner flange 78
25. Exhaust vent
26. Inhalation vent
27. Commutator
28. Insulating tip
29. Carbon brush
30. Brush holder cap
31. Screwdriver
GA7040S GA9030/GA9030S
6.5 mm 6.5 mm
-1
6.4 kg
/II
separate collection point for municipal
waste, operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.23 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
GA9040S
230 mm
6.5 mm
M14
-1
6,600 min
511 mm
6.3 kg 6.7 kg
ENE048-1
ENF002-2
ENF100-1
5