RIDGID HD0600M0 Owner's Manual page 22

ASSEMBLY
1. Locate the Carry Handle and the two
(2) #10 x 19 mm (3/4") Pan Head
Screws in loose parts bag.
2. Position the Carry Handle on top of the
Powerhead Assembly, with the Carry
Handle Extended Flange to the rear of
the Powerhead, as shown.
3. Insert a #10 x 19 mm (3/4") Pan
Head Screw through the hole at each
end of the Carry Handle and into the
Powerhead Assembly. Tighten securely.
Extended
Flange
Inserting the Tug-A-Long
Positive Locking Hose with
Dual-Flex
1. Insert the larger end of the Tug-A-
Long Positive Locking Hose with Dual-
Flex into the Inlet Port. Engage the
Hose Latch to the lip of the Inlet Port.
The Hose should snap into place.
2. To remove the Tug-A-Long Positive
Locking Hose with Dual-Flex from the
Vac, press the Release Button on the
Hose and pull the Hose out of the Inlet
Port, as shown.
#10 x 19 mm
(3/4") Pan Head
Screws (2)
Carry Handle
Powerhead
Assembly
22
Powerhead
Assembly
Vac Inlet
Release
Button
Tug-A-Long Positive
Locking Hose with
Dual-Flex