Table of Contents
Advertisement
o Connect a 150 mm ducting hose to a discharge outlet that is suitable for cooking
vapours. Please note that the ducting hose is not supplied with the appliance but
one can be obtained from the Retail outlet where you purchased your appliance.
o The maximum distance between the coupling and your discharge outlet should
be 3 metres, with one 90 degree bend. For each additional 90 degree bend, the
maximum distance is reduced by a further metre.
o Before fixing the rangehood into the kitchen unit, you should connect the other
end of the ducting hose to the coupling in the top of the cooker hood.
Installing your rangehood (BRT90ISS)
1. The ceiling must can bear at least 40kgs weight, and the thickness of the ceiling
must be ≧30MM, see pic 2, drill 1*170mm round hole in the ceiling.
2. According to the hanging board, drill 12 holes in the ceiling, see pic 2, 12pcs of
ST6*40mm big flat screws will be used to fix the hanging board on the ceiling, and
then 8pcs of M4*10 screws and M4 nut with gasket will be used to connect the
angle iron into the hanging board, see pic 1, calculated the length of the angle iron,
and 16pcs M4*10 big flat screws and M4 nut with gasket will be used to connect
the angle iron and another angle iron ( the overlap length of angle iron can not less
100MM)
3. Let the one side of the extensible pipe go outside through the hole of 170MM, see
pic 3.
4. 4pcs ST4*8 big flat screws will be used to connect the internal chimney into the
hanging board, then put one the external chimney, two hooks will be used to put up
the external chimney in order to the next installation, see pic 4.
5. 4pcs ST4*8 big flat screws will be used to install the outlet, see pic 5.
6. Hold up the hood, 16pcs M4*10 big flat screws will be used to connect the hood
body into angle iron, see pic 6.
7. Put the extensible pipe on the outlet; after ensure all the things ok, put down the
hook, take from the external chimney, all the installation is finished, see pic7& 8.
17
Advertisement
Table of Contents
