Advertisement
Customize Your Network Security
When you irst set up your network, the setup uses a default encryption
key common to all PowerLINE adapters. You can change this.
¾ To create a private secure network:
1. Wait until the Pick A Plug LEDs are lit.
2. Press the Security button for two seconds on one adapter, and then
press the Security button on one of the other adapters for two
seconds. Both buttons must be pressed within two minutes.
Note:
The Security button does not work in power saving mode (see
Troubleshooting Tips
Warning: Do not press the Security button on the PowerLINE adapter
until installation is complete and the adapters are communicating with
each other (indicated by the Power LED). Pressing this button too soon
can temporarily disable PowerLINE communication. If this occurs, use the
Factory Reset button to return the PowerLINE adapter to its factory
default settings.
If you add adapters later, use this procedure to add the new adapters to
your secure network.
).
on page 13
12
Advertisement
