Assembly Instructions - Black & Decker BWDS Instruction Manual

SET UP & USE

ASSEMBLY INSTRUCTIONS

1. Using the diagram below as reference to position the poles, INSERT LB2-2
(LOWER LEFT BACK VERTICAL POLE) and LF1-2 (LOWER LEFT FRONT
VERTICAL POLE) into L-BP LEFT BASE. The base of the poles should be
positioned between the L-BP slots and aligned with the holes.
Use 25S (BUTTERFLY SCREW) to secure on each side. They should be inserted
from the outside of L-BP and inserted fully through the holes of the poles to
secure.
NOTE: Follow the same steps to assemble the right side.
Closeup of LF1-2 and
LB2-2 being inserted into
L-BP . Make sure holes are
aligned when inserted.
2. Insert LB2-1 (UPPER LEFT BACK VERTICAL POLE) into LB2-2 (LOWER LEFT
BACK VERTICAL POLE).
Insert LF1-1 (UPPER LEFT FRONT VERTICAL POLE) into LF1-2 (LOWER LEFT
FRONT VERTICAL POLE).
LF1-2
L-BP
LB2-1
LB2-2
LB2-2
25S
LF1-2 LB2-2
L-BP
LF1-1
LF1-2
25S
Page 7