Advertisement
Cruise control function
The cruise control function allows the
operator to maintain a constant speed without
pulling the trigger. To increase the speed, turn
the control lever forward. To decrease the
speed, turn the control lever backwards.
1
► 1. Control lever
Accidental restart
preventive function
If you turn on the machine while pulling the switch
trigger or while the control lever is not in the off
position, the machine does not start. To start the
machine, first release the s witch trigger and return the
control lever fully, and then turn on the machine.
Electronic function
The machine is equipped with the electronic function
for easy operation.
Constant speed control
•
The speed control function provides the constant
rotation speed regardless of load conditions.
OPERATION
CAUTION: Do not place the machine on the
ground while it is switched on. Sand or dust may
enter from suction inlet and cause a malfunction or
personal injury.
Vacuuming operation
CAUTION: When performing the vacuuming
operation, be sure to remove the blower pipe
and nozzles from the machine, and attach the
suction pipe, suction nozzle, elbow pipe, dust
bag, and shoulder strap to the machine.
CAUTION: Check the dust bag frequently for
wear or deterioration.
CAUTION: Be sure to fasten the fastener of
the dust bag before operating the machine.
CAUTION: Always switch off the machine
before opening or fastening the fastener of the
dust bag.
NOTICE: Do not allow wet materials such as
wet leaves, and foreign materials such as large
wood chips, metal, glass, pebbles, etc., to be
sucked into the machine. Otherwise a
malfunction may occur.
NOTICE: Empty the dust bag before it
becomes full. Otherwise, a malfunction may
occur.
NOTICE: To prevent the suction of
foreign materials, operating the machine
in the vacuuming mode is recommended
1. Put the shoulder strap and dust bag on the
shoulder as shown in the figure. Adjust the
length of the strap
4
► 1. Shoulder strap 2. Carry handle
Assist handle 4. Dust bag
2. Hold the carry handle with your right
hand and the assist handle with the
other hand.
3. While operating the machine, adjust the
switch trigger so that the suction force is
appropriate for the work location and
conditions.
1
2
Advertisement
