Advertisement
NOTE: Depending on the conditions of use and
the ambient temperature, the indication may
differ slightly from the actual capacity.
Machine/battery protection system
The machine is equipped with a machine/battery
protection system. This system automatically cuts off
power to the motor to extend machine and battery
life. The machine will automatically stop during
operation if the machine or battery is placed under
one of the following conditions:
Overload protection
When the machine or battery is operated in a
manner that causes it to draw an abnormally high
current, the machine automatically stops and the
lamp for mode 1 blinks in green. In this situation,
turn the machine off and stop the application that
caused the machine to become overloaded. Then
turn the machine on to restart.
Overheat protection
When the machine or battery is overheated, the
machine stops automatically and the lamp for
mode 1 lights up in red. In this case, let the
machine and battery cool down before turning the
machine on again.
Overdischarge protection
When the battery capacity is not enough, the
machine stops automatically and the lamp for
mode 1 blinks in red. In this case, remove the
battery from the machine and charge the battery.
Main power switch
WARNING: Always turn off the
main power switch when not in use.
To turn on the machine, press the main power
switch. The lamps for mode 1 and mode 2 light up in
green. To turn off, keep pressing the main power
switch until the lamps for mode 1 and mode 2 go off.
1
(1) Lamp for mode 1 (2) Lamp for mode 2
►
(3) Main power switch
2
3
You can use the machine in the vacuuming mode.
In the vacuuming mode, the suction volume
becomes smaller than in the normal mode.
When you turn on the machine, the machine starts
up in the normal mode. To use the machine in the
vacuuming mode, press the main power switch
when the machine is turned on. The lamp for mode
2 goes off and only the lamp for mode 1 lights up in
green. When you press the main power switch
again, the machine returns to the normal mode, and
the lamps for mode 1 and mode 2 light up in green.
NOTE: The lamp for mode 1 blinks in green if
the machine is operated under unoperatable
conditions. The lamp blinks in one of the
following conditions.
The switch trigger is pulled, when the
•
bolt on the fan cover or suction pipe is
not tightened firmly, or the bolt on the
blower pipe or elbow pipe is not
tightened firmly.
The machine is turned on, when the
•
control lever is not fully returned to the
off position, or while you are pulling the
switch trigger.
NOTE: This machine employs the auto
power-off function. To avoid unintentional
start up, the main power switch will
automatically shut down when the switch
trigger is not pulled for a certain period after
the main power switch is turned on.
Switch action
WARNING: Before installing the battery
cartridge into the machine, always check to
see that the switch trigger actuates properly
and returns to the "OFF" position when
released.
1
► 1. Switch trigger
To start the machine, simply pull the switch trigger. The
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
Advertisement
