Hitachi BD-W80PAE Operating & Installation Instructions Manual page 25

Front loading washing machine
Table of Contents

Advertisement

d
d
How to Install the Washing Machine
How to Install the Washing Machine
Make sure that the union nut between the water supply hose and main
Make sure that the union nut between the water supply hose and main
unit is tightly screwed.
unit is tightly screwed.
Turn the tap on to check if the water supply hose is properly connected
Turn the tap on to check if the water supply hose is properly connected
before starting. If it is loosely connected, water leakage may occur.
before starting. If it is loosely connected, water leakage may occur.
Drain hose
Drain hose
The drain hose should be placed higher than 60 cm above and not
The drain hose should be placed higher than 60 cm above and not
higher than 100 cm above the fl oor.
higher than 100 cm above the fl oor.
If the drain outlet is lower than 60 cm,
If the drain outlet is lower than 60 cm,
a joint pipe is necessary (additional
a joint pipe is necessary (additional
part, sold at a specialist outlet).
part, sold at a specialist outlet).
Secure the drain hose to prevent from
Secure the drain hose to prevent from
slipping out from joint pipe.
slipping out from joint pipe.
Do not bend, twist, crush or pull out, bend or step on the drain hose.
Do not bend, twist, crush or pull out, bend or step on the drain hose.
Use the hose guide to prevent the drain hose from kinking.
Use the hose guide to prevent the drain hose from kinking.
Do not detach the drain hose from the rear panel of the washing
Do not detach the drain hose from the rear panel of the washing
machine.
machine.
Drainage into a wash basin (Using the packed-in hose guide) :
Drainage into a wash basin (Using the packed-in hose guide) :
Drainage into a siphon :
Drainage into a siphon :
60~100 cm
60~100 cm
Joint pipe
Joint pipe
- Secure the drain hose to prevent it from
- Secure the drain hose to prevent it from
slipping out of the wash basin.
slipping out of the wash basin.
- The wash basin outlet must not be sealed
- The wash basin outlet must not be sealed
by a plug.
by a plug.
- When water is being pumped out of the
- When water is being pumped out of the
washing machine, check that the water
washing machine, check that the water
drains away quickly enough.
drains away quickly enough.
- Secure the connection point with
- Secure the connection point with
φ
φ
24-40 mm
24-40 mm
hose clip (Sold at a
hose clip (Sold at a
specialist outlet).
specialist outlet).
25
25
3WPL079591-2
3WPL079591-2

Advertisement

Table of Contents
loading

Table of Contents