Hitachi BD-W80PAE Operating & Installation Instructions Manual page 24

How to Install the Washing Machine How to Install the Washing Machine
Conecting the Conecting the
water supply water supply
24 24
3WPL079591-2 3WPL079591-2
● ● Water supply hose Water supply hose
■ ■
Optimum water pressure is 0.03-0.8MPa. Optimum water pressure is 0.03-0.8MPa.
■ ■
Do not connect to the mixer tap of an unpressurised hot-water Do not connect to the mixer tap of an unpressurised hot-water
apparatus. apparatus.
■ ■
Use a horizontal tap. Use a horizontal tap.
Horizontal tap Horizontal tap
Connect the water supply hose to the rear panel of Connect the water supply hose to the rear panel of
the washing machine. the washing machine.
Make sure that the rubber seal is inside the hose Make sure that the rubber seal is inside the hose
connector. connector.
* Model with SCREW TYPE water supply hose. * Model with SCREW TYPE water supply hose.
Firmly connect the water supply hose to the tap, and Firmly connect the water supply hose to the tap, and
check connection points for water-tightness. check connection points for water-tightness.
* Model with ONE TOUCH JOINT water supply hose. * Model with ONE TOUCH JOINT water supply hose.
1. Untighten the upper connector 1. Untighten the upper connector
screw. screw.
Upper connector Rubber packing Upper connector Rubber packing
Fixing screw Fixing screw
● ●
In case the diameter of the tap In case the diameter of the tap
is large remove the guide plate. is large remove the guide plate.
Guide plate Guide plate
Connector Connector
3. Connect the water supply 3. Connect the water supply
hose to the middle connector, hose to the middle connector,
pushing the plate down. pushing the plate down.
Middle connector Middle connector
Water supply hose Water supply hose
Extension tap Extension tap Square tap Square tap
Hose connector Hose connector
Rubber seal Rubber seal
2. Push the upper connector up 2. Push the upper connector up
till the rubber packing is in till the rubber packing is in
tight contact with the tap. Then tight contact with the tap. Then
tighten the 4 screws. tighten the 4 screws.
Middle Middle
Rubber packing Rubber packing
connector connector
Upper connector Upper connector
Middle connector Middle connector
● ●
Turn the middle connector so Turn the middle connector so
that there is no water leak. that there is no water leak.
● ●
To separate the water supply To separate the water supply
hose from the middle connector hose from the middle connector
shut off the tap. Then pull the shut off the tap. Then pull the
inlet hose down, pushing the inlet hose down, pushing the
plate down. plate down.