Performing A Demo Print; To Perform A Demo Print - Casio Printer CW-75 User Manual

Performing a Demo Print

The following describes how to perform a demo print, which uses built-in sam-
ple data to print a label.
Important!
Performing a demo print causes any label data you are working with to be
deleted. If you want to keep label data you are working on, use the procedure
under "Saving Labels in Memory" on page 50 to save it before performing the
following procedure.

To perform a demo print

1.
Check to make sure that the printer has an ink ribbon cassette loaded.
2.
If the printer is turned on, press ] to turn it off.
3.
Press [ to turn on the printer.
4.
Press SET UP to display the SET UP menu.
5.
Use the cursor keys to select DEMO PRINT and then press SET.
6.
Use the x and z cursor keys to select DATA1 or DATA2 as the data you
want to print, and then press SET.
7.
Use the x and z cursor keys to select PRINT and then press SET.
8.
Use the c and v cursor keys to select either LABEL1 (upper label area)
or LABEL2 (lower label area), and then press SET.
9.
Place the disc onto the disc tray.
• If the disc tray does not open, press the
printer. See "Changing the Tray Auto Open Setting" on page 55 for
configuring the disc tray auto open setting.
56
E
button on the top of the
10.
Press SET.
• This starts the print operation.
• DATA1 and DATA2 of the sample are printed at two locations on the
disc. For more information, see "To print a label with text in both areas
(Label 1 and Label 2)" on page 52.
11.
After printing is complete, the disc tray will open part way. Carefully pull
out the disc tray and remove the disc.
12.
After you are finished printing, use the x and z cursor keys to select
EXIT, and then press SET.
13.
In response to the confirmation message that appears, press SET.