Table of Contents
Advertisement
To avoid damage to the
IDR-M mimic and to the fire
control panel ensure that
you follow these
997-412-000-3, Issue 3
June 2005
IDR-M Mimic Installation & Commissioning Manual
instructions
2.3 Installation
The IDR-M mimic is relatively simple to install
provided the recommended procedures
described in this Installation Guide are
followed.
Follow all installation instructions
described
in
instructions must be understood and the
manufacturer's recommendations followed
to avoid damage to the IDR-M mimic and
to the fire control panel and associated
equipment.
2.3.1 Checking Your Equipment for
Damage
It is important to check all supplied
equipment for damage before proceeding
with the installation!
Before attempting to install your IDR-M mimic,
you should do the following:
1 After
removing
(dependent upon your configuration) from
its packaging, and before you proceed with
the installation, check for any damage that
may have been caused while in transit.
Note: In the unlikely event that the any of the
components of the IDR-M mimic have
been damaged, you MUST NOT install
it but return it to your supplier. The
procedure for returning faulty items is
described in Section 2.3.2, What to do
if Your Equipment is Damaged or
Suspect.
2 If you are satisfied that none of the
components of the IDR-M mimic have been
damaged you can now commence the
installation procedure. This manual
addresses the recommended installation
methods for the IDR-M mimic. Refer to the
relevant sections that apply to your
configuration requirements.
To prevent unnecessary damage to the
electronic components, the IDR-M mimic
PCBs should only be installed in an enclosure
AFTER that enclosure has been fitted to the
wall.
6
this
manual. These
each
component
Advertisement
Table of Contents
