NEC SL2100 Hardware Manual page 152

ISSUE 4.0
6.3.3 Installing The AC Adapter
1. Using both thumbs, press down on the raised ridges of the adapter cover on the repeater until you
hear a click.
2. Being careful not to angle the cover, gently pull to remove it.
3. Insert the AC adapter connector into the yellow adapter opening. Thread the cord according to the
illustration.
4. Carefully replace the cover, and press until you hear it click. Do not angle it as you replace it.
5. Use the AC adapter to connect the repeater to a standard 120 V AC outlet. (Do not use an outlet
controlled by a wall switch!) The LED on the repeater flashes briefly, then remains on and steady.
6.3.4 Activate Registration Mode On Base
You need to activate registration mode on your base before you can register your repeater to it. Refer
to the Owner's Manual for your base unit for registration instructions.
You only have to activate registration on the base once, regardless of how many repeaters you want to
register (up to 6).
6.3.4.1 Register Repeater to Base
You can register up to six repeaters to each base. Repeat these steps as needed for each repeater.
The repeater seeks out the base with strongest DECT/GAP signal and automatically registers to that
INSTALLING WIRELESS DECT TELEPHONES
Figure 2-155 Removing the Adapter Cover
Figure 2-156 Threading the AC Adapter Cord
SL2100
150