Sirius Radio Messages; Resetting The Main Unit; Switching The Speaker Impedance - Pioneer VSX-917V Operating Instructions Manual

Additional information

SIRIUS radio messages

Symptom
Antenna Error
Check Sirius Tuner
Acquiring Signal
Subscription Updating
Updating Channels
Invalid Channel

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the  STANDBY/ON button
for about three seconds.
3 When you see RESET? appear in the
display, press ENTER.
OK? shows in the display.
4 Press SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory settings.
Cause
Antenna is not properly connected.
SIRIUS Connect tuner is not properly connected Check that the 8 pin mini DIN cable
The SIRIUS signal is too weak at the current
location.
Unit is updating subscription.
Unit is updating channels.
Selected channel is not available/does not exist. Select another channel.
Action
Check that the antenna cable is
attached securely.
and AC Adapter are attached securely.
n/a
Wait until the encryption code has
been updated.
Wait until the encryption code has
been updated.
Switching the speaker
impedance
We recommend using speakers of 8 Ω with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6 Ω impedance rating.
With the receiver in standby, press 
•
STANDBY/ON while holding down the
SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6 Ω.
• SP 8 OHM – Use this setting if your
speakers are rated at 8 Ω or more.
12
69
En