Selecting Preset Codes Directly; Erasing One Of The Remote Control Button; Settings; Erasing All Of The Remote Control Presets - Pioneer VSX-917V Operating Instructions Manual

09 Controlling the rest of your system

Selecting preset codes directly

RECEIVER INPUT
SELECT
F.AUDIO
TV DVR
DVD
CD-R/TAPE XM RADIO SIRIUS
CD FM AM
SLEEP SB ch
1 While pressing the RECEIVER button,
press and hold the SETUP button.
The remote LCD display shows SETUP.
Use / to select PRESET then press
2
ENTER.
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER.
The LCD on the remote displays the
component you want to control.
Use / to select the first letter of the
4
brand name of your component then press
ENTER.
This should be the manufacturer's name (for
example, P for Pioneer).
Use / to select the manufacturer's
5
name from the list then press ENTER.
Use / to select the proper code from
6
the list, then try using this remote control
with your component.
The code should start with the component type
(for example, DVD 009). If there is more than
one, start with the first one.
To try out the remote control, switch the
component on or off (into standby) by pressing
SOURCE . If it doesn't seem to work, select
the next code from the list (if there is one).
Note
1 You can't assign the RECEIVER button.
48
En
SOURCE
SR+ DIMMER
SIGNAL SEL
D.ACCESS
CLASS
+10
ENTER
TOP MENU
TUNE
DTV MENU ST ST
TV CTRL
ENTER
SETUP
TUNE
RECEIVER
CATEGORY
GUIDE
TV CONTROL
ANALOG
ATT
INPUT
TV VOL TV CH VOL
SELECT
1
7 If your component is controlled
successfully, press ENTER to confirm.
The remote LCD display shows OK.
MIDNIGHT
Erasing one of the remote
control button settings
DISC
This erases a control assigned to one of the
MENU
buttons and restores it to the factory default.
T.EDIT
RETURN
1 While pressing the RECEIVER button,
press and hold the SETUP button.
The remote LCD display shows SETUP.
Use / to select ERASE then press
2
ENTER.
3 Press the MULTI CONTROL button
corresponding to the button setting to be
erased then press ENTER.
The LCD on the remote displays the
component.
4 Press and hold the button to be erased for
two seconds.
The LCD display shows OK or NO CODE to
confirm the button has been erased.
5 Repeat step 4 to erase other buttons.
6 Press the RECEIVER button when you're
done.
Erasing all of the remote control
presets
This will erase all preset remote control preset
codes.
1 While pressing the RECEIVER button,
press and hold the SETUP button.
The remote LCD display shows SETUP.
Use / to select RESET then press
2
ENTER.