Advertisement
Before You Begin
Before you begin, check that you have received all of the parts listed below. If any parts are missing
or damaged, contact your dealer immediately.
•
Camera
•
Self-tapping screws (×4)
•
Documentation CD
•
Plastic wall anchors (×4)
•
Quick install guide
•
Mounting template
Required tools:
•
A Phillips screwdriver
•
A drill with an appropriately-sized drill bit for pre-drilling holes for the screw anchors.
CAUTION
Installation and servicing should be performed only by qualified
and experienced technicians to conform to all local codes and to maintain your
warranty.
M3X18 self-tapping
Phillips pan head screw
1
Removing the Ball Camera from the Base
From the back of the camera base, push the ball camera free from the gland cover on the
camera base. Set the ball camera body aside.
2
Preparing the Mounting Surface
1.
Place the mounting template on the mounting surface where you want to install the camera.
2.
Drill three (3) holes in the mounting surface for the wall anchors. Insert the wall anchors.
3.
Drill an appropriately sized hole and pull the cables through the mounting surface.
© 2014 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell. The information in this publication is believed to be accurate in all respects. However,
Honeywell cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
Ceiling or wall
Wall anchor
Camera base
ST3x18 self-tapping screw
Gland cover
Decorative ring
Ball camera body
H2D2PR1(X) 1080p TDN IR Ball IP Camera
3
Mounting the Camera
1.
Route the cables through the camera base.
2.
Align the screw holes on the camera base with the plastic wall anchors.
3.
Insert the three self-tapping screws through the holes in the camera base, into the wall
anchors, and then tighten them to secure the camera base in place.
4
Installing and Adjusting the Ball Camera
1.
Loosen, but do not remove, the M3X8 cross-recessed pan head slot screw on the camera
base. This screw secures the gland cover and camera in place.
2.
Adjust the gland cover to the desired position, and then re-tighten the M3X8 cross-recessed
pan head slot screw to secure the gland cover in place.
3.
Connect the IP cable to the RJ-45 port on the ball camera.
4.
Firmly push the ball camera body back into the gland cover on the camera base until it
securely clicks into place.
5.
Adjust the lens to the desired angle.
5
Installing the Decorative Ring
When you have achieved the desired field of view, install the decorative ring.
1.
Align the three tabs on the decorative ring with the slots on the camera base.
2.
Turn the decorative ring clockwise until it securely clicks into place.
https://www.honeywellsystems.com/ss/techsupp/index.html
www.honeywell.com/security
+1 800 323 4576 (North America only)
Document 800-17073V1 – Rev A – 07/2014
Advertisement
