Temperature / Humidity Transmitter (
感謝您購買本公司的產品!為使產品能正常運作,請您詳閱使用手冊,並請依照說明操作。謝謝!
Thanks for choosing our product! Please read carefully and follow this instruction before using!
產品附件清單 Product accessories list
產品:壁掛式 Wall mount
1.
附件:如下
傳訊器
螺絲 Screws
使用說明書 Manual
產品中有害物質的名稱及含量
產品:外氣式 Outside Air
2.
附件:如下
傳訊器
螺絲 Screws
使用說明書 Manual
產品中有害物質的名稱及含量
安裝方式 Installations
請選定安裝傳訊器的位
1.
Please decide right position for installation.
將底座以螺絲固定在欲安裝的牆面或裝線盒上
2.
Fix the base with screws on the wall
○
請依接線圖連接訊號線 (電阻&電壓輸出,請參考接線圖一)
1
Please refer Figure 1 (Resistance & Voltage Output ).
○
將 PC 板(LED 面朝上),插入接線端子台,並將 PC 板崁入正確位置
2
Connect properly the PC board to the terminal ( LED is on top )
安裝線材請採用隔離線(15AWG / 17AWG / 22AWG)
3.
Please apply 15AWG / 17AWG / 22AWG cable for installation.
*注意:接線前後,請勿接上電源,以免造成機板損壞,或發生危險
Notice: Please remove power from unit before wiring input and output connection, in order to avoid any damage or hazard.
接線方式如下:
Please refer to the wiring Figures as following
端子接線方式 Wiring figure
NTC20k/ Pt1000&電壓輸出
圖一
Figure 1
* 注意: 請勿接線或碰觸到 AC 110 ~ 220V 的電源
Notice: Do not connect to AC 110 ~ 220V power supply.
** NTC 20K 2-wire 式 sensor 直接連接"A,B" 端子輸出;若 Pt1000 3-wire 式 sensor 直接連接"A,B,b"端子即可。
NTC 20K 2-wire type directly connected to the "A, B" terminal output; if Pt1000 3-wire directly connected "A, B, b" terminal output.
溫溼度傳訊器(NTC20k/Pt1000 & 電壓輸出)使用說明書
數量:1
數量:4
數量:1
數量:1
數量:1
數量:4
數量:1
數量:1
(RL> 2.5KΩ at 24V DC)
Output
Voltage
NTC20k/Pt1000
& Voltage Output) Manual
:
AC/DC24
NTC20K And
Pt1000 Sensor
1
3WIA-0B2700-060