Advertisement
Optional features
Tamper – Enabled by default and activated when the mounting plate is removed. The tamper is
normally closed and changes to open circuit between Tamper 1 and Tamper 2 control lines. Tamper 1
and Tamper 2 control lines are interchangeable. Either of these lines can be connected with the reader
ground line to reduce the number of cable cores required in the reader cable. Tamper 1 and Tamper 2
are rated 0–12VDC at 100mA.
Hold Input – When asserted, this line either buffers a card (default) or disables a card read until
released, as configured.
Specifications
20
INPUT VOLTAGE (V DC)
CURRENT
STANDBY AVG
1
60 mA
MAX AVG
2
70 mA
PEAK3
250 mA
OPERATING
TEMPERATURE
CABLE LENGTH
RS-485 = Max bus length: 4,000 ft - 24 AWG (1,219 m)
Max length between nodes: 1,640 ft - 24 AWG (500m)
REGULATORY REF
20
NUMBER
FREQUENCY
FCC IDS
JQ6-SIGNO20
IC IDS
2236B-SIGNO20
1 Standby AVG - RMS current draw without a card in the RF field.
2 Maximum AVG - RMS current draw during continuous card reads. Not evaluated by UL.
3 Peak - highest instantaneous current draw during RF communication.
Regulatory
UL
Connect only to a Listed Access Control / Burglary power-limited power supply. These readers are intended
to be used with listed (UL294) control equipment. Suitable for outdoor use.
Only Wiegand, OSDP, and Bluetooth communications have been evaluated by UL.
HID Signo readers are compatible with HID Mobile Access® version 3.0.0 and later using mobile devices with
BLE version 4.2 and later listed at:
https://www.hidglobal.com/mobile-access-compatible-devices.
Install in accordance with NFPA70 (NEC) Local Codes, and authorities having jurisdiction. Follow all National
and Local Codes.
UL 294 Performance Levels
ACCESS
CONTROL
DESTRUCTIVE
MODEL #
LINE
SECURITY
LEVEL
20 / 20K / 40 / 40K
Level I
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAUTION: Any changes or modifications to this device not explicitly approved by the manufacturer could
void your authority to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
ƒ Reorient or relocate the receiving antenna.
ƒ Increase the separation between the equipment and receiver.
ƒ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
ƒ Consult the dealer or an experienced radio/TV technician for help.
Canada Radio Certification
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Russia
Дата изготовления указана на маркировке оборудования
Представитель в Российской Федерации
Название
ООО «Дофин»
Адрес
140573, РФ, Московская обл., Озерский район, с. Бояркино
Контактное лицо
Л.Н. Голубова
Телефон
+7 495 223 6008
e-mail
local.declarant@gmail.com
20K
40
12V DC
65 mA
65 mA
75 mA
75 mA
250 mA
250 mA
-30° F to 150° F (-35° C to 66° C)
Communication Lines
Wiegand = 500 ft - 18 AWG (152 m)
300 ft - 20 AWG (91 m)
20K
40
BLE: 2.4–2.480 GHz, HF: 13.56 MHz, LF: 125 kHz
JQ6-SIGNO20K
JQ6-SIGNO40
2236B-SIGNO20K
2236B-SIGNO40
ENDURANCE
STAND-BY
ATTACK
LEVEL
POWER LEVEL
LEVEL
Level I
Level IV
Level I
CE Marking
HID Global hereby declares that these proximity readers are in compliance with the essential requirements
and other relevant provisions of Directive 2014/53/EU.
Por el presente, HID Global declara que estos lectores de proximidad cumplen con los requisitos esenciales
y otras disposiciones relevantes de la Directiva 2014/53/EU.
HID Global déclare par la présente que ces lecteurs à proximité sont conformes aux exigences essentielles
et aux autres stipulations pertinentes de la Directive 2014/53/EU.
A HID Global, por meio deste, declara que estes leitores de proximidade estão em conformidade com as
exigências essenciais e outras condições da diretiva 2014/53/EU.
HID Global bestätigt hiermit, dass die Leser die wesentlichen Anforderungen und anderen relevanten
Bestimmungen der Richtlinie 2014/53/EU erfüllen.
HID Global dichiara che i lettori di prossimità sono conformi ai requisiti essenziali e ad altre misure rilevanti
come previsto dalla Direttiva europea 2014/53/EU.
Download copies of the Radio Equipment Directive Declaration of Conformity (DoC) at:
40K
http://www.hidglobal.com/certifications
Taiwan
根據NCC低功率電波輻射性電機管理辦法 規定:
70 mA
第十二條
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻
率、加大功率或變更原設計之特性及功能。
80 mA
第十四條
低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即
250 mA
停用，並改善至無干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。
Korean KCC
항목
송신주파수
수신주파수
출력
40K
전원
전파형식
발진방식
변조방식
JQ6-SIGNO40K
2236B-SIGNO40K
Israel
Brazil
Compliance Statement
Este produto está homologado pela ANATEL, de acordo com os procedimentos regulamentados pela
Resolução 242/2000, e atende aos requisitos técnicos aplicados. Para maiores informações, consulte o
site da ANATEL - www.anatel.gov.br
This product is homologated at ANATEL according to procedure regulated by Resolution 242/2000, and
it complies with the applicable technical requirements. For more information, consult ANATEL website -
www.anatel.gov.br
RF Warning Statement
Per Article 6 of Resolution 506, equipment of restricted radiation must carry the following statement in a
visible location:
Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência
prejudicial, mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em
caráter primário.
CONDITIONS
This equipment operates in secondary character, meaning it does not have the right of protection against
harmful interference, even against those the same character, and it cannot cause any interference to
systems operating in the primary character.
Singapore
Complies with
Complies with
IMDA Standards
IMDA Standards
DB106440
DB106440
South Africa
Signo 20
Signo 40
Equipment
8T2 9
ACC Control READER
20, 20K, 40, 40K
규격
RFID:13.56 MHz
RFID:13.56 MHz
RFID: 10m에서 47.544mv이하
DC 12.0V
A1D
X-tal
RFID: ASK, NFC: GFSK
.יטוחלא הלעפה ןוישרמ רוטפו ״ינשמ״ סיסב לע וניה רישכמב שומישה
.יטוחלא הלעפה ןוישרמ רוטפ חוקלה ,דבלב חוקלה לש ימצע שומישל ״קזב תלועפב״ קר
.רחא ינכט יוניש לכ וב תושעל אלו ,רישכמה לש תירוקמה הנטנאה תא ףילחהל רוסא
Australia and
New Zealand
E4662
E4662
Signo 20K
TA-2019/2225
APPROVED
Signo 40K
TA-2019/2224
APPROVED
General Signaling
Equipment
Ukraine
TA-2019/2226
APPROVED
TA-2019/5040
APPROVED
15
E4662
Advertisement
