Makita DTW181 Instruction Manual page 8

the battery
the groove
housing and
into place.
all the
it locks
with a
If you
the red
the upper
the button,
not locked
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may accidentally
out of
causing injury
or someone around
CAUTION:
Do not install the battery cartridge
forcibly. If the
not slide
it is
inserted correctly.
Tool / battery protection system
The tool is
a tool/battery protection system.
This system
cuts off
the motor
tool and
The tool
automatically
operation if
or battery
under one of the following conditions:
Overload protection
When the battery
in a
causes it
an abnormally high
the tool
stops without
indication. In
turn the tool off and stop the
application that caused the tool to become overloaded.
Then turn the tool on to restart.
Overheat protection
When the tool/battery is
overheated,
stops automatically.
this situation, let
tool/battery cool
tool on again.
All manuals and user guides at all-guides.com
cartridge with
in the
slip it
Insert it
way until
in place
little click.
can see
indicator on
side of
it is
completely.
fall
the tool,
to you
you.
cartridge does
in easily,
not being
equipped with
automatically
power to
to extend
battery life.
will
stop during
the tool
is placed
is operated
manner that
to draw
current,
automatically
any
this situation,
the tool
In
the
before turning the
Overdischarge protection
When the
not
stops
this
battery
and
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.2:
button
Press the
the
indicate
capacity.
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature,
indication may
from
Switch action
►
Fig.3:
CAUTION:
Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start
pull
Tool
increased by
8 ENGLISH
battery capacity
enough, the
automatically.
case, remove
from the
charge the
1. Indicator lamps 2. Check
check button
battery cartridge
the remaining battery
The indicator
Off Blinking
75
50
25 % to 50%
The
malfunctioned.
the
differ
the actual
1. Switch trigger
the tool,
the switch
speed is
increasing pressure
is
tool
In
the
tool
battery.
on
to
lamps
Remaining
capacity
% to 100%
% to 75%
0 % to 25%
Charge the
battery.
may
ba
slightly
capacity.
simply
trigger.