Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita DTW181Z
Summary of Contents for Makita DTW181Z
- Page 1 INSTRUCTION MANUAL Cordless Impact Wrench DTW181 Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model: DTW181 Fastening capacities Standard bolt M8 - M16 High tensile bolt M6 - M12 Square drive 12.7 mm No load speed Hard impact mode 0 - 2,400 min Soft impact mode 0 - 1,300 min Impacts per minute Hard impact mode 0 - 3,600 min Soft impact mode... -
Page 3: Safety Warnings
Personal Safety EC Declaration of Conformity Stay alert, watch what you are doing and use common sense when operating a power tool. For European countries only Do not use a power tool while you are tired or The EC declaration of conformity is included as Annex A under the influence of drugs, alcohol or med- to this instruction manual. - Page 4 Do not expose a battery pack or tool to fire or Power tool use and care excessive temperature. Exposure to fire or tem- Do not force the power tool. Use the correct perature above 130 °C may cause explosion. power tool for your application. The correct power tool will do the job better and safer at the Follow all charging instructions and do not rate for which it was designed.
-
Page 5: Functional Description
If not, causing fires, personal injury and damage. It will it may accidentally fall out of the tool, causing injury to also void the Makita warranty for the Makita tool and you or someone around you. charger. - Page 6 Overheat protection Switch action When the tool/battery is overheated, the tool stops automatically. In this situation, let the tool/battery cool before turning the tool on again. Overdischarge protection When the battery capacity is not enough, the tool stops automatically. In this case, remove the battery from the tool and charge the battery.
- Page 7 Pull the switch trigger to turn on the lamp. To turn off, release it. The lamp goes out approximately 10 seconds after releasing the switch trigger. To keep the lamp off, turn off the lamp status. First pull and release the switch trigger. And then press the but- for one second within 10 seconds.
- Page 8 Changing the impact force You can change the impact force in three steps: hard, soft, and Reverse rotation auto stop mode. This allows a tightening suitable to the work. Every time the button is pressed, the number of blows changes in three steps. ►...
- Page 9 For impact socket with O-ring and pin ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Selecting correct impact socket Always use the correct size impact socket for bolts and nuts.
-
Page 10: Operation
Proper fastening torque for standard bolt Installing hook CAUTION: When installing the hook, always N•m secure it with the screw firmly. If not, the hook (kgf•cm) may come off from the tool and result in the personal (1840) injury. (1630) (1430) (1220) (1020) -
Page 11: Optional Accessories
CAUTION: These accessories or attachments NOTE: If the tool is operated continuously until the are recommended for use with your Makita tool battery cartridge has discharged, allow the tool to rest specified in this manual. The use of any other... - Page 12 Jan-Baptist Vinkstraat 2, Makita Europe N.V. 3070 Kortenberg, Belgium 3-11-8, Sumiyoshi-cho, Makita Corporation Anjo, Aichi 446-8502 Japan 885668-227 www.makita.com 20180708...