Installation; Picture 6.73; Picture 6.74 - Beko Arcelik BLG15 C7S Service Manual

While there is a clearance of 2 cm between the lower right and left side, pull the
front wall downwards to complete the removal process.

Picture 6.73

Installation

6.9
Check if the lower right and left plastic pin parts are attached at the concrete
counterweight level on the body.
If the holder is not in the proper location or in its housing, or if it is directed towards
somewhere else in its location, it must be corrected with pliers.
The holder plastic parts, which are found near the upper left and right corner on the
front wall, must be attached.
The front wall is held near the Left and Right side lower toeboard.
The front wall is aligned on the body in its general location.
Nest the Front Wall plastics, which are going to be attached to the sections on the
body.
Upon making sure that the upper plastic holders are seated in their places, locate the
lower part in parallel with the body and push it upwards slightly.
2 screws on flanges on the panel connection top are installed.
X
2

Picture 6.74

Sensitivity: Public
BLG15 C7S SERVICE MANUAL
The plastic holder pins must
be fixed to the body and
secured in their places. The
flat side must be parallel to
the floor.