Dome Light Replacement - Honda in-Vehicle Entertainment System Operating Instructions Manual

1. Turn the Monitor dome light switch to the OFF position.
2. Insert a small straight blade screw driver into the rear slot on the light lens. (see Fig. 1)
Gently pivot the screw driver toward the rear of the monitor. The lens should pop out
slightly.
3. Pivot the lens away from the monitor and towards the front of the monitor.
4. Remove the bulb by pushing toward the front clip.
5. Replace with a 12 V - 3 watt bulb. Insert the bulb into the front clip, and then position
into the rear.
Caution: Use only a 3-Watt bulb replacement. Do not use a 5-Watt bulb
replacement! Use of a higher wattage bulb may cause damage to your system
and increase the risk of a burn from high heat.
6. Replace the lens by sliding the front edge under the dark plastic IR lens at the front of
the monitor. (See Fig. 2)
7. Pivot the lens toward the rear of the monitor. Align the 2 tabs on the lens over
the rectangular holes on the top of the monitor. Gently push the lens into the monitor
at the rear snap. (See Fig. 3)
-25-