Advertisement
●
Apply the heating dimple head gently to the face and slowly move the device by
sliding it from the center of the face to the outer side.
●
Do not apply the device on the same area of skin for more than 10 seconds.
If you feel your skin tingling by micro current while using the device, press the Level
●
switch button and switch to "L."
6 After 3 minutes have elapsed, the device will automatically shut off. (Auto shutoff function)
●
The finish sound will inform you.
7 Wipe off the lotion on the heating dimple head and the body of the device with a tissue.
Step 4
"COOL"
This mode cools the cooling head surface to about 10℃ below the surrounded temperature
by cooling effect to tighten your skin.
CAUTION
Continuous use of the "COOL" mode makes it difficult to cool the cooling head.
The warning sound and the flashing "COOL" on the mode indicator lamp will inform you.
The warning sound can be canceled by pressing the power switch, but the "COOL"
mode cannot be used for about one hour after cancellation.
"HOT CLEANSING," "HOT MOISTURIZE" and "HOT MASK" can still be used.
1 Press the power switch. (Fig.13)
●
The level indicator lamp will turn off, and "
flashing. If a lamp in another mode is flashing, press the mode switch button to
switch to "
COOL
When the " HOT MASK " mode is finished, press the power switch and the "
mode will automatically be set.
2 Wait until the cooling head has cooled.
●
Preparation for cooling takes about 10 seconds. "
flashes during preparation.
●
When the device is ready for use, the ready sound will beep and the mode indicator
lamp will be turned on.
CAUTION
The device does not vibrate in "
3 Apply the cooling head gently to your skin and move it slowly just like patting your face.
(Fig.14)
●
The mode indicator lamp will change to lighting from flashing.
The cooling head does not vibrate.
●
The time for use is within 1 minute and 50 seconds.
●
Since you can apply the device to the same area of your skin for only one second,
repeatedly apply the head to your skin on and off towards the face.
●
There is no indicating timer function in the "COOL" mode.
Do not keep the heating dimple head on the same area of skin, it is
necessary to move it around.
(Cause of problems with your skin or physical discomfort.)
Use this device at surrounded temperature from 15 to 35℃. (If you
use "
" mode at low temperature without the suggested range,
COOL
the head may be overcooled. It may hurt your skin.)
."
COOL
COOL
" on the mode indicator lamp starts
" on the mode indicator lamp
COOL
" mode.
-13-
"
COOL
Advertisement
