Advertisement
4 Choose "the strength" of electrical potential with the Level switch button. Switch the
"strength" with the Level switch button according to the condition of your skin.
●
Every time the level indicator button is pressed, the "L","M" and "H" of the electrical
potential will be switched. There will be no change in vibration strength.
●
The memory function memorizes the "strength" when the power has been shut off.
It is recommended that when using the device for the first time or if you feel some
discomfort, use the device in "L."
5 Hold the device with your hand touching the back plate of the body. (Fig. 8)
●
Make sure to hold the body with your hand touching the back plate.
6 Apply cotton to the skin and move the device slowly. (Fig. 9)
●
The mode indicator lamp will turn on and the device will start to vibrate.
●
The time for use is within 3 minutes.
CAUTION
Unless you apply cotton puff to your skin while touching the back plate, the device
will not vibrate. (Skin sensing function)
If the heating dimple head is not vibrating, the device is not working.
If you leave the device as it is for about 3 minutes without vibration, the device will
automatically switch "Off." (Automatic shutoff function)
Indicating Timer Function
Skin care time is indicated by the buzzer beeping about every 45 seconds as a guide.
[Example of skin care sequence] (Fig. 9)
Divide the area from your face to décolletage into four zones as shown in the
illustration. By moving the heating dimple head in the order of ①②
③
④décolletage, the whole area can be efficiently and uniformly cared for.
●
Apply the cotton gently to the face and slowly move the device by sliding it from the
center of the face to the outer side.
The vibration may change while using the device. This is because the spot sensor
senses the cotton. This is not a failure.
●
Add more toner when there is no moisture in the cotton or when the device is
difficult to slide.
●
Do not apply the device on the same area of skin for more than 10 seconds.
●
If you feel your skin tingling by micro current while using the device, press the Level
switch button and switch to "L."
If you still feel your skin tingling, use the device by adding more toner.
7 After 3 minutes have elapsed, the device will automatically shut off. (Auto shutoff function)
●
The finish sound will inform you.
8 Remove the ring and the cotton.
●
Wipe off the surface of the head with a tissue.
●
Do not use the cotton again once it is used. It might cause problems with your skin.
When not using cotton
Also you can use the device without cotton in "Hot Moisturize."
Do not keep the cotton on the same area of skin, it is necessary to
move it around.
(Cause of problems with your skin or physical discomfort.)
-10-
Advertisement
