Advertisement
3. Place the spacers and kickers inside the mower deck
while aligning the mounting holes (Fig. 2).
4. Secure each kicker to mower deck with a 5/16–18 x 1"
bolt and 5/16-18 locknut (Fig. 2). The bolt heads are to
be positioned inside the mower deck.
.
1
Figure 2
1. Kicker
Installing the Recycler
1. On Groundsmaster mowers, use the dimensions shown
in figure 3 to locate, mark and drill (2) .344" dia. holes
thru top of the mower deck.
6.14
11.92
Figure 3
2. Place the left and right sides of the baffle into the
mower deck.
3. Position the baffle sides together using the alignment
pin on the flanges (Fig. 4).
2
2. Spacer
Baffle
®
4.78
10.08
3
1
Figure 4
1. Alignment pin
2. Baffle kicker (3)
4. Align two of the baffle holes with the holes previously
drilled in the mower housing. Make sure there is
clearance between the blades and the baffles.
5. Using the baffles as templates, mark the hole locations
for the remainder of the holes in the mower housing
(Fig. 4). Only drill one additional hole for mounting
the right baffle flange (Fig. 4).
6. Remove the baffles from the mower housing and drill
.344" dia. holes at the marked locations.
7. Secure the baffle flanges together with a 5/16-18 x
5/8" bolt and 5/16" locknut (Fig. 4).
8. Place baffle assembly inside cutting chamber and align
the mounting holes (Fig. 5).
3
2
Figure 5
1. Baffle left side
2. Baffle right side
2
2
3. Use one of these holes as
a template to locate hole
in mower housing
3
3
3. Use the washers at these
locations
1
Advertisement
