Download Print this page

Advertisement

Quick Links

Recycler Kit
For 52" ProLine and Groundsmaster
Model No. 59225
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION
Kicker
Bolt 5/16–18 x 1"
Spacer
Locknut 5/16-18
®
Recycler
blade
Baffle left side
Baffle right side
Bolt 5/16–18 x 5/8"
Washer 5/16"
Locknut 5/16-18
Pre–Installation
1. Remove the mower from the traction unit. Refer to the
Mower Operator Manual for instructions.
2. Thoroughly clean the mower. All debris must be
removed to ensure the kickers and baffle will fit tightly
against the mower deck.
3. Repair all bent or damaged areas of mower and
replace any missing parts.
Install Kickers
1. Tip the mower upside down and block up the ends to
ease the installation of the kickers.
2. On Groundsmaster mowers, use the dimensions shown
in figure 1 to locate, mark and drill (3) .344" dia. holes
thru the top of mower deck.
Note: Before drilling the holes, align the kickers with the
hole marks to make sure they fit in the mower deck.
W 1998, 2007 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
)
Mowers
QTY.
3
3
Install kickers
3
3
3
Replace standard blades on mower
1
1
9
Install Recycler
®
3
9
6.81
.15
1
Form No. 3321–650 Rev. A
Installation Instructions
USE
baffles
6.54
5.80
1.79
Figure 1
All Rights Reserved
Printed in the USA
3.43

Advertisement

loading

Summary of Contents for Toro 59225

  • Page 1 Note: Before drilling the holes, align the kickers with the hole marks to make sure they fit in the mower deck. W 1998, 2007 by The Toro Company 8111 Lyndale Avenue South All Rights Reserved...
  • Page 2 3. Place the spacers and kickers inside the mower deck while aligning the mounting holes (Fig. 2). 4. Secure each kicker to mower deck with a 5/16–18 x 1” bolt and 5/16-18 locknut (Fig. 2). The bolt heads are to be positioned inside the mower deck.
  • Page 3 9. Loosely install the baffle flanges to the housing with 3. Install previously removed 5/16–18 x 5/8” (16 mm) (3) 5/16–18 x 5/8” bolts, washers and 5/16-18 locknuts bolts and 5/16-18 locknuts in open holes of mower for (Fig. 5). The bolt heads are to be positioned inside the safety (Fig.