Sanding Operation - Makita BO5040 Instruction Manual

OPERATION
CAUTION:
• Always use the front grip and irmly hold the
tool by front grip and switch handle during
operations.

Sanding operation

CAUTION:
• Never run the tool without the abrasive disc. You
may seriously damage the pad.
• Never force the tool. Excessive pressure may
decrease the sanding eficiency, damage the
abrasive disc or shorten tool life.
• Using the tool with the pad edge contacting the
workpiece may damage the pad.
Hold the tool irmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad lush with the work-
piece and apply slight pressure on the tool.
CAUTION:
• The sanding pad rotates clockwise during the
loaded operation, but it may rotate counterclock-
wise during the no-load operation.
Polishing operation
For Model BO5041
CAUTION:
• Use only a Makita genuine sponge pad, felt pad
or wool pad (optional accessories).
• Always operate the tool at low speed to prevent
work surfaces from heating abnormally.
• Never force the tool. Excessive pressure may
decrease the polishing eficiency and cause
motor overload, resulting in tool malfunction.
1. Applying wax
1
1 . Sponge pad
Use an optional sponge pad. Apply wax to the
sponge pad or work surface. Run the tool at low
speed to smooth out wax.
NOTE:
• First, wax a not conspicuous portion of the
work surface to make sure that the tool will not
scratch the surface or result in uneven waxing.
• Always run the tool at low speed. Running it at
high speed may cause the wax to spatter.
2. Removing wax
1
1 . Felt pad
Use an optional felt pad. Run the tool at low speed
to remove wax.
8 ENGLISH