Makita BO5040 Instruction Manual page 5

The tool speed can be ininitely adjusted between 4,000
and 12,000 orbit per minute by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 5; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the igure for the relationship between the num-
ber settings on the adjusting dial and the kind of work.
A range: For polishing
B range: For inish sanding
C range: For regular sanding
12,000
4,000
A
1
2
NOTE:
• The igure shows standard applications. They
may differ under certain conditions.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
How to use the front grip
The front grip can be loosened and moved horizontally
to a desired working position. Once the front grip is in
the desired position, retighten before using.
C
B
3 4
Dial setting
Installing or removing the front grip
1
2
1 . Screw 2. Front grip
Open the grip base, and attach it to the sander in the
area of the Makita logo.
5
1 . Grip base 2. Makita logo
After closing the grip base, irmly tighten on the front
grip to the screw section of the grip base.
To remove, loosen and remove front grip, and then
remove grip base.
5 ENGLISH
2
1