CHOKE CABLE INSTALLATION
1. Inspect:
NOTE:
Push the choke knob 1 entirely in before
installing it to the frame.
2. Install
NOTE:
Place the choke knob casing cap against the
stay 3.
3. Install:
NOTE:
Place the carburetor choke valve in its fully
open position a, insert the tip of the inner
cable into drum hole 5, and then secure it in
place with the screw 6.
SVU3850
THROTTLE CONTROL MOTOR
1. Inspect:
1
NOTE:
• Install the shaft a of the throttle control
motor by aligning it with the groove b of the
throttle shaft.
• Install the throttle valve, and then make sure
that is moves smoothly.
SVU3860
• When installing the engine, fully open the
throttle valve.
3-41
CARBURETOR
• Choke knob 1
• Casing cap (choke cable) 2
• Inner cable 4
Screw:
1 Nm (0.1 m · kg, 0.7 ft · lb)
• Throttle control motor 1
ENG