Table of Contents
Advertisement
NOTE
UNIVERGE WL Access Point (External-Antenna) Quick Installation Guide
Preparing a Version 2.0 UNIVERGE WL AP or
UNIVERGE WL 1200R
If your UNIVERGE WL AP has UNIVERGE WL Operating System 2.0 or a later
version (which includes all UNIVERGE WL 1200Rs) loaded on it, continue with
this procedure. If your AP has UNIVERGE WL Operating System 1.2 or earlier
loaded on it, or if you do not know what version the AP has loaded, use the
Preparing a Version 1.2 UNIVERGE WL AP
This procedure assumes that you are preparing a version 2.0 UNIVERGE
WL AP or UNIVERGE WL 1200R to inter-operate with a version 2.0
UNIVERGE WL Wireless Controller. When you are preparing a version 1.2
UNIVERGE WL AP to inter-operate with a version 1.2 UNIVERGE WL
Wireless Controller, use the procedure found in the version 1.2 UNIVERGE
WL Access Point Quick Installation Guide.
Configuration Setup
Does My AP Qualify for this Procedure?
•
If your 2.0 or later version UNIVERGE WL AP or UNIVERGE WL 1200R
cannot be configured for any reason using the following procedure, refer
to RMA Procedures located in the UNIVERGE WL Product Documentation.
Preparing a Version 2.0 UNIVERGE WL AP or UNIVERGE WL 1200R
procedure above.
Configuration Setup
Does My AP Qualify for this Procedure?
1-7
Advertisement
Table of Contents
