Initializing Tpm For Bitlocker Users; Initializing The Tpm 1.2 For Txt Users; Initializing The Tpm 2.0 For Txt Users; Control Panel - Dell EMC PowerEdge R940 Installation And Service Manual

Initializing TPM for BitLocker users

Steps
Initialize the TPM.
For more information, see https://technet.microsoft.com/en-us/library/cc753140.aspx.
The TPM Status changes to Enabled, Activated.

Initializing the TPM 1.2 for TXT users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On with Pre-boot Measurements.
4. From the TPM Command option, select Activate.
5. Save the settings.
6. Restart your system.
7. Enter System Setup again.
8. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
9. From the Intel TXT option, select On.

Initializing the TPM 2.0 for TXT users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.
6. Enter System Setup again.
7. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
8. Select the TPM Advanced Settings option.
9. From the TPM2 Algorithm Selection option, select SHA256, then go back to System Security Settings screen.
10. On the System Security Settings screen, from the Intel TXT option, select On.
11. Save the settings.
12. Restart your system.

Control panel

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the fan cage.
4. Remove the air shroud.
5. If installed, remove the expansion card
6. If installed, remove the
122 Installing and removing system components
Safety instructions
Before working inside your system
risers.
PEM.
on page 29.
on page 30.