Specifications - Makita AN450H Instruction Manual

ENGLISH (Original instructions)
3-1. Pneumatic oil
4-1. Adjuster
5-1. Hook
6-1. Contact element
6-2. Shingle guide
6-3. Shingle
6-4. Projection
7-1. Lever
7-2. Adjust plate
8-1. Magazine cap
8-2. Latch lever

SPECIFICATIONS

Min. hose diameter
Pneumatic tool oil
Dimensions (L X H X W)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
9-1. Coil support plate
9-2. Graduation
9-3. Arrow
10-1. Feed Claw
11-1. Air fitting
11-2. Air socket
12-1. Trigger
12-2. Contact element
13-1. Trigger
13-2. Workpiece
13-3. Contact element
Model
Air pressure
Nail length
Nail capacity
Net weight
) : 84 dB(A)
pA
) : 97 dB(A)
WA
END106-3
Vibration
The vibration emission value determined according to
EN792:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
ENE059-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENG905-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
14-1. Trigger
14-2. Change lever
15-1. Trigger
15-2. Change lever
16-1. Small rod
16-2. Ejection port
18-1. Cap
19-1. Drain cock
20-1. Air filter
21-1. Oiler
21-2. Pneumatic oil
AN450H
1.28 - 2.26 Mpa (12.8 - 22.6 bar)
19 mm - 45 mm
120 pcs.
5.0 mm
Turbine oil
287 mm X 276 mm X 117 mm
2.3 kg
) : 3.0 m/s
h
2
ENG904-1
2
ENG901-1