Cleaning And Disinfecting; Bilisoft Light Box - GE BiliSoft Operation And Maintenance Manual

Cleaning and Disinfecting

BiliSoft Light Box

WARNING:
Make sure the light box power cord is disconnected from the power source
before cleaning and that the unit is completely dry before using it.
WARNING:
Never immerse the light box in liquid. Water will short circuit electronic
circuitry, causing permanent damage.
CAUTION:
Use the cleaning solution sparingly on a cloth when cleaning the exterior of the
light box. Do not saturate the cloth - excessive solution may flow into the light
box causing damage to internal components.
CAUTION:
Do not autoclave or gas sterilize the Light Box.
1. Unplug the power cord.
2. Clean the outside of the light box using a mild detergent solution. Aqueous solutions,
which are both hospital disinfectants and microbactericides, may be used. Do not
allow liquids to seep into the housing. Apply the cleaning solutions with a clean cloth
or sponge. Always dry the parts with a clean damp soft cloth to avoid scratches and
remove cleaner residue. Do not spray cleaner directly on the unit. Take caution if
wiping inside of the fiberoptic light pad assembly port not to damage the LED shutoff
switch. See table on page 7-4 for a list of approved cleaners.
7-2 M1110147 Rev. 5 © 2007 Datex-Ohmeda. All rights reserved.