Fujitsu AU G18LVLB Series Service Instruction page 103

3-1-3 INDOOR UNIT ( For AB type)
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control,
in accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value.
Settings will not be changed if invalid numbers or setting values are selected.
Filter sign
The indoor unit has asign to inform the user that itis time to clean the filter. Select the
time setting for the filter sign display interval in the table below according to the amount
of dust or debris in the room. if you do not wish the filter sign to be displayed, select the
setting value for "No indication".
(for AB*G18LVTB.AB*G22/24LVTA)
Standard (400 hours)
Long interval (1000 hours)
Short interval (200 hours)
No indication
(for AB*G30/36LRTE.AB*G45LRTA)
Standard (2,500 hours)
Long interval (4,400 hours)
Short interval (1,250 hours)
No indication
Seiling height
Select the setting values in the table below according to the height of the ceiling.
*When using floor console installation, don't need to change the setting value.
Cooler room temperature correction
Depending on the insralled environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Standard
Slightly lower control
Lower control
Warmar control
Heater room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Standard
Slightly warmer control
Lower control
Warmar control
When using floor console installation, change the setting value to "01".
Setting Description
Setting Description
Setting Description
Standard
High ceiling
Setting Description
Setting Description
03-05
( Factory setting)
Function Number Setting Value
00
01
11
02
03
( Factory setting)
Function Number Setting Value
00
01
11
02
03
( Factory setting)
Function Number Setting Value
20
( Factory setting)
Function Number Setting Value
30
( Factory setting)
Function Number Setting Value
31
00
01
00
01
02
03
00
01
02
03