Advertisement
5869
HOLD-UP SWITCH/TRANSMITTER
INSTALLATION
Mount the 5869 under a counter or
money drawer for easy access by the
cashier. Refer to the steps and figures
that follow for typical mounting
instructions. Before mounting the 5869
permanently, perform Go/No Go tests
to verify adequate transmitter signal
strength at desired mounting location
(refer to the Security System Control
Panel Installation and Setup Guide).
PROGRAMMING
Hold-Up
The 5869
Switch/Transmitter
should be programmed as a 24-hour
silent zone type. Refer to the Security
System Control Panel Installation and
Setup Guide for programming
instructions.
MOUNTING
COVER
HOLE
SCREW
TRIGGER
COVER
SCREW
MOUNTING
HOLE
HOLDUP
TRANSMITTER
DEVICE
Figure 1
ORDERING
5869
Hold-Up Switch/Transmitter
1. Remove the two screws (Figure 1)
securing the cover to the 5869 case.
NOTE: The holes located in the opposite corner
to the screws that secure the cover to the case,
provide a means for securing the transmitter to
the counter or drawer.
2. Using the case as a drill
template, position the case
in the desired location.
3. Drill a 1/16
"
pilot hole at the
breakaway tamper release
hole and the two case mounting
holes (Figure 2).
• During programming of the control
panel, the 5869
Switch/Transmitter should be treated
as "RF" (i.e., supervised RF) Type
• The 5869 is one closed input loop
zone (loop 1)
RESET
KEY
COVER
MOUNTING
ATTACH
HOLE
HOLE
BREAKAWAY
TAMPER
RELEASE TAB
SCREW
HOLE
COVER TAMPER
COVER
RELEASE SWITCH
ATTACH
HOLE
+
MOUNTING
HOLE
INSIDE VIEW
WITH
CIRCUIT BOARD
5869-001-V0
4. Attach the case to the counter or
5. Install the battery (see BATTERY
6. Secure the cover to the case with
7. Secure the assembled case to
Battery Installation/Replacement
Hold-Up
1. Remove and retain screws securing
2. Observing correct polarity, insert the
NOTE: Use care not to bend the antenna while
attempting to install battery.
3. Re-install screws to secure cover
RESET
KEY
MOUNTING
HOLE
TRIGGER
BREAKAWAY
TAMPER
RELEASE
SCREW HOLE
BREAKAWAY
TAMPER
RELEASE
COVER
ATTACH HOLE
money drawer using one No. 6 x 3/4
screw (supplied) at the breakaway
tamper release.
INSTALLATION/REPLACEMENT).
the two screws removed in step 1.
the counter or drawer using the
two No. 6 x 2 mounting screws
supplied (Figure 2).
the 5869 cover.
battery into the battery holder.
and/or assembly. Refer to Figure 1.
NOTE
CIRCUIT BOARD REMOVED
FOR CLARITY ONLY. DO NOT
COVER
REMOVE CIRCUIT BOARD
ATTACH
DURING INSTALLATION.
HOLE
COVER
COVER
SCREW (2)
No. 6X1/2
+
MOUNTING
SCREW (2)
No. 6X2
CIRCUIT
BOARD
TRIGGER
INDEX
HOLE
TAB
COVER
TAMPER
RELEASE
SWITCH
3V
+
MOUNTING
LITHIUM
HOLE
BATTERY
+
COVER
SCREW
5869-002-V0
Figure 2
Advertisement
