Instructions To The Homeowner; Turning Off The Appliance - Honeywell WV4262B Installation Instructions Manual

WV4262B POWERED DAMPER WATER HEATER CONTROLS
INSTRUCTIONS TO THE
HOMEOWNER
WARNING
Fire or Explosion Hazard.
Can cause severe injury, death, or property
damage.
Follow these warnings exactly:
1. IF YOU SMELL GAS:
a. Turn off the gas supply at the appliance ser-
vice valve. On LP gas systems, turn off the
gas supply at the gas tank.
b. Do not light any appliances in the house.
c. Do not touch electrical switches or use the
phone.
d. Leave the building and use a neighbor's
phone to call your gas supplier.
e. If you cannot reach your gas supplier, call
the fire department.
2. The water heater control must be replaced in
event of any physical damage, tampering, bent
terminals, missing or broken parts, stripped
threads, or evidence of exposure to heat.
WARNING
Scalding Hazard.
Can cause burns, severe injury, or death.
Never move temperature setpoint knob past
the B setting without checking water
temperature at the faucet, and re-adjusting
until comfortably warm to the touch. Consider
the ages and health of all who will come into
contact with heated water.
IMPORTANT
Follow the operating instructions provided by
the manufacturer of your water tank appli-
ance. The information in this form describes a
typical water heater control application, but
the specific controls used and the procedures
outlined by the manufacturer of your appli-
ance can differ, requiring special instructions.
WARNING
Electrical Shock Hazard.
Can cause severe injury, death, or property
damage.
Disconnect power supply before making
wiring connections to prevent electrical shock
or equipment damage.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
customer.honeywell.com
STOP: READ THE
WARNINGS.
TURNING ON THE
APPLIANCE
If the appliance does not turn on when the setpoint
knob is set several degrees above the previous
temperature, follow these instructions:
1. Set the temperature setpoint knob to its lowest
setting to reset the safety control.
2. Disconnect all electric power to the appliance.
3. Turn off the main gas supply to the appliance.
4. Wait five minutes to clear out any unburned gas.
If you then smell gas, STOP! Follow Step 1 in the
Warning above. If you DO NOT smell gas, con-
tinue with the next step.
5. Turn on the main gas supply to the appliance.
6. Reconnect all electric power to the appliance.
7. Turn the setpoint knob to the desired setting.
8. If the appliance does not turn on, there may be
residual air in the gas supply line.
a. Set the temperature setpoint knob to its low-
est setting to reset the safety control.
b. Turn the setpoint knob to the desired set-
ting.
c. Turn the Control's power switch to the OFF
position, then turn it back ON to restart the
90 second air-purge cycle for the gas sup-
ply.
9. If the previous step does not turn on the appli-
ance, turn off the main gas supply to the appli-
ance and contact a qualified service technician
for assistance.
TURNING OFF THE
APPLIANCE
Shutdown
1. Turn device knob to LOW. Turn off the gas sup-
ply to the appliance. Appliance will completely
shut off.
2. Follow the procedure in the Instructions To The
Homeowner section above to resume normal
operation.
® U.S. Registered Trademark
© 2016 Honeywell International Inc.
69-2496—03 M.S. Rev. 10-16
Printed in United States