Setting The Ex90 In Standby; Shutting Down The Ex90; Reverting To Factory Default Settings - Cisco TelePresence EX90 User Manual

Cisco TelePresence System EX90

Setting the EX90 in standby

Outside a call, you may have the unit enter standby mode by touching the
Power button on the main unit (the screen). The Standby dialog is displayed
and the unit enters standby immediately. This does not work when you are in a
call.

Shutting down the EX90

Outside a call, press the Power button until the Shutdown progress bar is filled
completely.
Release the button and the unit will go in shutdown in just a few seconds.
User guide EX90, TC4.2, July 2011.
D14724.06
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
All manuals and user guides at all-guides.com
Tap as shown to
wake up the system
from standby.
To start the system again,
press the Power button
until the LED illuminates
(green light).
26

Reverting to factory default settings

To revert to the factory default settings, do as follows:
1. Disconnect the power cord.
2. Reconnect the power cord—a green light will illuminate shortly after.
Press the Power button as soon as the green light appears. Keep it de-
3.
pressed for 15 seconds or so, until the green light starts flashing.
4. Release the button and press twice within 2 seconds. All settings will now
revert to factory default settings.
User guide
www.cisco.com