Table of Contents
Advertisement
3-4. Replacing the Main Parts
16. Open the SA-37 board by raising it from the right side.
n
Be careful that the harness of the jog dial is connected
to the board at the left.
17. Remove the harness for small parts (DIAL) that is
connected to the SA-37 board from the connector
(CN1).
SA-37 board
CN1
Harness for
small parts
(DIAL)
18. Peel off the sheet (B) from the LCD unit.
19. Peel off the shielding foil tape (C) on the upper side of
the LCD unit.
3-16 (E)
Sheet (B)
Shielding foil tape (C)
20. Remove the four screws (P2 x 5) that fix the LCD
unit.
21. Remove the LCD unit.
22. Remove the LCD shield case from the LCD unit.
LCD unit
P2 x 5
P2 x 5
Installation
Attach a new LCD unit by reversing the disassembly
procedure of steps 1 through 22.
n
If the shielding foil tape (C) is stuck, apply SONY BOND
(SC608) to the end portion where the tape is peeled off.
Part name : SONY BOND SC608
Part No. :
7-432-912-52
Apply here.
LCD shield case
P2 x 5
P2 x 5
Apply here.
MAV-555
Advertisement
Table of Contents
