Table of Contents
Advertisement
4. Remove the FAN harness from the harness clamp
under the fan bracket of the fan (a).
5. Remove the reusable band under the fan bracket of
fans (b) and (c).
Harness clamp
Fan (a)
Fan (b)
6. Remove the four screws and remove the finger guard,
fan, and fan bracket.
Fan bracket
Fan (a)
Finger guard
B4 x 45
B4 x 45
B4 x 45
n
Loosen the screw of the harness clamp that is fitted to the
fan bracket and remove fan (a).
MAV-555
Remove it while
pushing.
Reuseable band
Fan (c)
Fan (b)
Fan (c)
B4 x 45
Installation
1. Attach a new fan by reversing the disassembling
procedure of steps 1 through 6.
(For connecting the harness, refer to Section 3-2-4.)
n
. Be careful not to pinch portion d of the fan harness
between the fan and rear panel.
. Put the fan harness under all harnesses to prevent it
from touching the blades, and connect the fan
harness.
. When the cable clamp is attached, attach the harness
clamp as shown below.
PSW3 x 6
Harness clamp
3-4. Replacing the Main Parts
d
Cable clamp
3-9 (E)
Advertisement
Table of Contents
