Advertisement
Description & Commissioning
Finding an S-Quad device
The 'find device' is a function that gives a visual or audible indication at the respective S-Quad device on a loop circuit.
Press the Menu On/Off button and then [Test/Eng] .
a.
Select [Loop] and then [Find Dev].
b.
Now enter a Loop card number to select the loop circuit.
c.
Select [Start] and type in a device number (usually device 1 is entered).
d.
Select [Enter]. The display shows the device and loop number.
e.
Number 1 on Loop 1
Press [Next] to find the next device on the loop and at any stage if the previous device needs to be
f.
found then select [Previous].
A found device will provide visual or audible indication:
¨
On any S-Quad device there will be a flashing indication given by the local LED.
¨
An S-Quad with Sounder, but without speech, will cause the Sounder to output pulsed tone
¨
An S-Quad with Visual Alarm will cause the light to operate.
¨
An S-Quad with Speech will cause a tone followed by announcement of a test message: "This is a test
message no action is required".
Loop loading
The 'Battery Standby and Loop Load calculator' tool is available via Gentexpert website. The tool must be used to accurately
determine the loop loading, cable length for lumped loads and to ensure the devices installed on each loop are within the maximum
allowed and will meet the control panel's standby requirement.
Turbo and Non Turbo Modes
The S-Quad devices can output in turbo and/or in non turbo modes. When the panel commands a low or high tone output at
S-Quad, if configured during commissioning, the S-Quad will output turbo and/or non turbo tones. The high and low FAB mappings
are used to change the tone output of the S-Quad sounder. The turbo mode outputs a waveform with a basic frequency that is the
same frequency as the resonant frequency of the S-Quad piezo. The non turbo mode outputs modulated turbo waveform.
No.
Description
0
Turbo square wave
1
Turbo high tone
2
Turbo low tone - high output
3
Turbo low tone
4
Turbo rich high tone
5
Turbo rich low tone
Non-Turbo square wave
8
Non-Turbo high tone
9
Non-Turbo low tone - high output
10
Non-Turbo low tone
11
Non-Turbo rich high tone
12
Non-Turbo rich low tone
13
"
The volume levels and power requirements of the S-Quad operating in turbo mode are significantly higher
than in non-turbo mode.
18
Turbo square wave
Turbo high tone
Turbo low tone - high output
Turbo low tone
Turbo rich high tone
Turbo rich low tone
S-Quad
Non-Turbo square wave
Non-Turbo high tone (Default)
Non-Turbo low tone - high output
Non-Turbo low tone (Default)
Non-Turbo rich high tone
Non-Turbo rich low tone
4188-1073 issue 3_2-17_P2_S-Quad
Advertisement
