Download Print this page

HIKVISION 1006KI How To Use

Hide thumbs Also See for 1006KI:

Download this manual

How to use 1006KI control analog PTZ which is

directly connected

Page 1 How to use 1006KI control analog PTZ which is directly connected...
Page 2 If you want to use the 1006KI to connect more than 1 PTZ directly by RS485 without DVR, you need to make sure you use the parallel connection. 1. Open the device and choose SET button. 2. Choose the System...
Page 3 E.g. If the SW1 switch on the PTZ 1 is 1, we need to set our Add. Bit as 1 too. And normally the default Baud Rate is 2400. For the Protocol, you can choose the HIKVISION. Then press OK button to save the setting. Then we have finished 1 PTZ’s setting. You also need to configure another 4 Notice: I have confirm with R&D colleague that all kinds of analog speed dome...
Page 4 5. Then press the MODE button to pick the control mode : 6. To Analog Dev 6. If you want to control the PTZ which address is 1, you can press the button 1 and CAM. Then you can use the joystick to control it. For another PTZ, you can also do the operation as the same.
Page 5 Thanks...