Table of Contents
Advertisement
Setting up
Set up Computer
1
Insert
USB Key
into USB port on your computer
If you already have an earlier version of FlipShare installed, launch FlipShare and
you will be prompted to upgrade, otherwise, open
FlipShare (PC) or Start FlipShare (Mac
Follow the onscreen instructions
Ensure that FlipShare is running prior to setting up the
If you are upgrading an existing version of FLIPSHARE with standard definition movies created using the "Create Movie"
feature, these movies will be updated to become compatible with FlipShare TV
depending on how many movies you have. The process runs in the background and, once completed, your movies will
be available for display on FlipShare TV
.
®
2
FlipShare TV
®
and launch Setup
FLIPSHARETV
)
®
TV Base
. The updating process duration will vary
®
Set up TV
2
Connect the
TV Base
using the
A/V cable
supplied for Analog Standard Definition TV or
using an HDMITM cable for HDTV
(cable sold separately)
FlipShare
TV Base
Check the Wireless Signal Indicator on the back of the
then the signal is good and you may proceed to the next step. If a red light is displayed then
the
TV Base
has not established a connection with the
then the signal is too weak.
Please see FlipShare TV
Switch on your TV and use your TV remote to select the television input/source that
corresponds to where you connected FlipShare TV
After a few moments FlipShare TV
is ready for use
®
Connect the
Power Adapter
to the
OR
TV
Base. If a blue light is displayed
USB
Key. If a purple light is shown
Setup Tips on page 7 for more information.
®
.
®
See television manual for instructions.
3
Advertisement
Table of Contents
