ABB ACH580-01 V R Series Instructions Manual page 6

REPLACEMENT INSTRUCTIONS | ACH580-01 VXR UL TYPE 1 , R2/R3/R4
Step Instruction
17
R4 Frame: Secure input and motor wires to the conduit plate.
18
Reconnect the RS485 terminal block
secure with zip ties
Reconnect any control wiring removed in steps 4 and 5.
WARNING! This configuration does not support Safe Torque Off (STO)
functionality in bypass mode.
19
Place the top of the drive cover on first, then press down on the
bottom.
R3 & R4 Frame: Using a T20 bit, torque to 14 in-lb (1.5 Nm).
20
Place enclosure cover in place and secure using two (2) M4x16 screws
that were removed earlier.
Using a T20 bit, torque to 14 in-lb (1.5 Nm).
21
Power and reprogram the drive.
A
to EFB on control unit and
B
.
Diagram
B
B
6
A