Warning Buzzer - Canon DM-MV300E Manual

DM-MV300E/MV300iE/MV310E
CHAPTER 1. GENERAL DESCRIPTION OF PRODUCT
7-4 Battery status (Remaining battery, Warning indications, shut off by insufficient power)
Battery status
• When using the unit on a battery, the battery status is indicated in five steps, i.e. 100%, 75%, 50%, 25% and 0% (approximate
values) until the insufficient-power warning appears, then is reset by switching the power off. When the unit is off and on again,
the battery regains its power (the battery status indication shows higher) sometimes. However, once the battery low warning
appears, the Low battery warning is displayed even when the power is regained by turning the unit off and on.
• The battery status indication is off when using the unit on the AC power adapter. However, when the power level decreases,
because of some malfunction (dropping below the battery low level), the battery low warning will go on. Then, should the power
increase above the battery low level, the battery low warning will disappear.
• Battery low warning appears when the voltage across the battery connectors falls below approx. 6.3V (when using with this product)
7-5 System data indication
Data Code (Date&Time)
Data Code (camera data)
Time Code
Audio Mode (12/16bit)
WIDE/Normal
CGMS (warning)
SP/LP
* IF there is no tape, the Time Code is shown as "—:—:—:—" in the unrecorded portion.
* CGMS : When copying is prohibited, the LINE OUT, CVF (panel) do not appear.
7-6 Data code indication
It is possible to independently set the Data Code indications on/off (regardless the other on-screen character indications).
7-7 MP tape
MP tape cannot be recorded in the LP mode. Even with the LP mode selected in the Menu, the tape will be set to the SP mode forcibly.
Playback of LP-recorded tape is made in LP mode.

7-8 Warning buzzer

Warning buzzer is activated in the following cases :
Turning the power on
Insertion of a cassette with the erasure prevention tap set to SAVE (camera mode) pip-pip-pip
EJECT cover fully open (also in when power is off)
Recording start (camera mode)
Recording pause activation (camera mode)
Halfway pressed photo button ; OK status
Mode transition (VCR mode)
Photo recording start
Dew condensation, mechanism error, and 5 seconds before going off with
the 5-minute timer in the recording pause (*) mode
Setting button operation of an item which cannot be selected in the menu
20, 15, 10 seconds before going off with the 5-minute timer in the recording pause (*) mode beep-beep-beep
Self timer (simultaneous tally flashing)
Including recording pause (*) in the audio dubbing, AV insert modes.
*Frequency of the "pip" tone is 4 kHz, of the "beep" tone is 2 kHz, of the "buuh" tone is 1 kHz.
Camera Mode
Camera Picture Rec Search
× (Appears in LANC) × (Appears in LANC) ×— — —
× ×
K K
K 4 sec. indication ×
K Setting indication ×
×
K
K Setting indication K
Mode
1-30
VCR Mode
DIF Input Blue Back
×— — —
× F— — —etc. ×F— — —etc.
K Main unit K
×
K DIF side
×
K DIF side
×
K DIF side
K Setting indication K Setting indication K
Sound
pip
pippip
pip
pippip
pippip
pip
pip
beep (a simple tone) ×5 times
buuh
pippip ×8 times (every second)
pip ×8 times (every 0.25 second)
PB (incl. special playback)
K
K
K
K
K
K