Table of Contents
Advertisement
Available languages
Available languages
Installing cutting head
CAUTION:
Secure the cutting head firmly.
Otherwise the cutting head may rotate during opera-
tion and cause serious injury.
Insert the cutting head into the tool by turning it left and
right alternately. Then tighten the three bolts with the
hex wrench (5/32").
1
1
2
2
4
4
3
3
► 1. Cutting head 2. Bolt 3. Hex wrench (5/32")
4. Tighten
Hook
CAUTION:
Never hook the tool at high loca-
tion or on potentially unstable surface.
1
2
3
► 1. Groove 2. Hook 3. Screw
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
OPERATION
Adjusting shear blade
Adjust the side blade L to prevent the curl of the
workpiece from contacting the cutting head and the
workpiece.
Loosen bolts with the hex wrench (5/32"). Move the
side blade L back and forth to adjust it. Then tighten the
three bolts with the hex wrench (5/32").
► 1. Bolt 2. Side blade L
Lubrication
NOTICE:
or the mineral spirits for aluminum.
Before operation, always lubricate the following areas:
A
The cutting area of the workpiece.
B
The part of the center blade which contacts to the
workpiece.
C
The both sides of the center blade which contacts
1
to the side blade L and side blade R.
2
3
A
8 ENGLISH
2
1
Use the standard machine oil for steel
C
B
C
Advertisement
Table of Contents
