Related Manuals for Waspper W3000HG
Summary of Contents for Waspper W3000HG
- Page 1 Operation Manual W3000HG Engine driven Translation of the original operation manual *The picture serves for reference only and it may not represent an exact match of the device delivered...
-
Page 2: Table Of Contents
– washing of machinery, vehicles, structures, tools, facades, gardening tools, etc. combined with a high-pressure water supply (with added cleaning agents, wherever required); – operation with accessories using spare parts approved by Waspper s.r.o. - In an environment where the device will not be exposed to direct splashing of contaminated water with solid particles. -
Page 3: Scope Of Delivery
Hazard levels DANGER - Indication of an immediate danger potentially resulting in serious injuries or death. CAUTION - Indication of a potential hazardous situation that may result in light injuries. WARNING - Indication of a potential hazardous situation that may result in material damage. Safety features CAUTION - Safety features are designed to protect their users from injuries and these may not be altered in any way or even put out of order... -
Page 4: Commissioning
The high-pressure washer and the filling hose from Waspper s.r.o. (special accessories, catalogue number SP000-HI001) can be used for removal of surface water, e.g. from storm water reservoirs. The water in reservoir must be clean, free of any contaminants or sludge. -
Page 5: Engine
Engine MUST The engine be filled with the correct amount of engine oil supplied with the delivery before its first commissioning. The bottle with engine oil may contain larger amount than required for the particular engine type. For specifics refer to the Technical data section. -
Page 6: Engine Maintenance
CAUTION! starter cord recoil (engine resistance against the direction of starter cord pull) will draw your shoulder and hand towards the engine faster than you are able to release is, this may result in spraining, contusion or breakage of your limb. Once the engine has started up, shift the choke control lever RUN position SLOWLY. - Page 7 a reduced performance. Using the drain plug located on the bottom side of the carburettor, drain all petrol from DO NOT TIP THE ENGINE OVER. the tank and the carburettor. THERE IS AN OIL LEAKAGE HAZARD! It is recommended to change the engine oil at the end of the season.
-
Page 8: Pump
The engine oil included in the delivery exceeds the minimum quality requirements highly and it will ensure safe operation of the engine with minimum wear of their internal components under demanding operating conditions. When topping up the engine oil, use the type and brand of oil already matching the existing filling. -
Page 9: Troubleshooting
When using the self-priming water supply mechanism: Make sure the water inside the supply contained is placed as high as possible, when compared to the water supply into the pump. Higher elevation difference of water levels helps to simplify the priming and reduce cavitation - the phenomenon associated with release of air bubbles from the liquid. -
Page 10: Warranty
The position of all control and safety features illustrated in this manual corresponds with their actual positioning. This manual does not have to reflect any changes in design of control levers. Technical data Device type W3000HG Engine type Peggas 196cm3/ 3.85kw... -
Page 11: Declaration Of Conformity In Compliance With Eu Standards
EU Declaration of Conformity The company Waspper s.r.o. hereby declares that the high-pressure washers defined below comply with the relevant EU directives on occupational health and safety of the device operators. Any alteration of the device without the prior consent from the manufacturer will render this declaration void. - Page 12 This registration enables the customer to avoid further procedures, as submitting of the purchase receipt or the warranty certificate. 1. The manufacturer - Waspper s.r.o. - is liable for inherent defects of the product purchased, if such defects become evident within the warranty period.