Locating The End Of The Last Scene; Locating Scenes By Recording Date - Canon MD130 Instruction Manual

Playback
32
• The tape stops at or near the zero
mark, disappears and the correct
time code will be displayed again.
NOTES
If there are blank sections between recordings,
the zero set memory may not work correctly.

Locating the End of the Last Scene

After playing back a tape, use this
function to locate the end of the last
scene recorded in order to continue
recording from that point.
POINTS TO CHECK
Stop the playback before using this
function.
FUNC.
( 22)
1
Press .
FUNC.
2
Select ( ) [
press ( ).
3
Select ( ) [EXECUTE] and press
( ).
• "END SEARCH" appears.
• The camcorder rewinds/fast forwards
the tape, plays back the last few
seconds of the recording and stops the
tape.
• To cancel the search push the
joystick ( ) towards
NOTES
End search cannot be used once you remove
the cassette.
END SEARCH] and
.
If there are blank sections between
recordings, the end search may not work
correctly.
You cannot use the end search to locate the
end of a scene that was audio dubbed.

Locating Scenes by Recording Date

You can locate the change of the date/
time zone with the date search function.
Press or
controller.
• Press more than once to search for
further date changes (up to 10 times).
• To cancel the search press
NOTES
Recordings shorter than 1 minute per date/
time zone cannot be located with this function.
Date search may not function if the data code
is not correctly displayed.
on the wireless
.
STOP