List Of Messages - Canon MD130 Instruction Manual

List of Messages

Message
SET THE TIME ZONE,
DATE AND TIME
CHANGE THE BATTERY
PACK
THE TAPE IS SET FOR
ERASURE PREVENTION
REMOVE THE CASSETTE
CHECK THE INPUT
CONDENSATION HAS
BEEN DETECTED
CONDENSATION HAS
BEEN DETECTED
REMOVE THE CASSETTE
TAPE END
CHECK THE CASSETTE
[REC MODE]
CHECK THE CASSETTE
[AUDIO MODE]
CHECK THE CASSETTE
[BLANK]
CHECK THE CASSETTE
[INCORRECT TAPE
SPECIFICATION]
INCORRECT TAPE
SPECIFICATION
INPUT SIGNAL NOT
SUPPORTED
HEADS DIRTY, USE
CLEANING CASSETTE
COPYRIGHT PROTECTED
PLAYBACK IS
RESTRICTED
COPYRIGHT PROTECTED
DUBBING RESTRICTED
NO CARD
NO IMAGES
You have not set the time zone, date and time. This message
appears each time you turn the power on until you set the time
zone, date and time.
Battery pack is exhausted. Replace or charge the battery pack.
Cassette is protected. Replace the cassette or change the position
of the protect switch.
Camcorder stopped operating to protect the tape. Remove the
cassette and reinsert it.
The DV cable is not correctly connected to the DV terminal, or the
connected digital device is turned off.
The video input signal is in a different television system (NTSC).
Condensation has been detected in the camcorder.
Condensation has been detected in the camcorder. Remove the
cassette.
Tape reached the end. Rewind the tape or replace the cassette.
You attempted to dub audio on a tape recorded in a recording mode
other than SP.
You attempted to dub audio on a tape recorded with an audio mode
other than [ 16bit].
You attempted to dub audio on a tape with a blank section.
You attempted to dub audio on a tape recorded in HD standard.
You attempted to play back a tape recorded in a different television
system (NTSC) or in a recording standard not supported by this
camcorder.
The digital device connected with the DV cable is incompatible with
the camcorder.
Video heads are dirty. Clean the video heads.
You attempted to play back a copyright protected tape.
You attempted to dub a copyright protected tape. May also appear
when an anomalous signal is received during analog line-in
recording.
Memory card not is inserted into the camcorder.
No images are recorded on the memory card.
Explanation/Solution
Trouble?
79
24
17
83
19
61
–
85
85
–
65
65
65
–
–
–
2
64
64
20
–